SECO-LARM Video Balun Plate

Modular Snap-In Passive Video Balun

EVT-PBM-V17 (Male)
EVT-PBM-V27 (Female)

EVT-PBM-V17

View Enlargement

Dimensional Diagram

Product Info Sheet

Descriptions

The EVT-PBM-V1x is the easy way to quickly install any style of CCTV cameras throughout an entire building or an entire campus without expensive coax cable. These snap-in video baluns fit in standard modular single-gang wall plates with a 9/16" x 5/8" (16 x 14.5 mm) hole, such as those from Levitron or ICC. They can be used to prewire a new building, or to retrofit an existing building. Just put one plate with a snap-in video balun in each room which might be protected by a CCTV camera, and run low-cost CAT 5 or CAT 5e cable from the balun to a centralized DVR or passive video hub.

For CCTV cameras at up to 2,000 ft. (610m) away.
Up to 0.6 miles (1km) when used with active receiver.
Modular snap-in connector fits standard single gang wall plates.
Surge protection.

Choice of gold-plated male or female BNC connector.
Built-in RJ-45 female connector on back for easy plug-in of low-cost CAT 5 or CAT 5e cable with standard RJ-45 male plug.
Use with low-cost CAT 5 cable instead of costly coaxial cables.

Specifications

Video Format	RS170, NTSC, PAL, SECAM, CCIR
Maximum Input	1vpp
Insertion Loss	< 2dB per pair from DC ~ 8 Mhz
Return Loss	>-15dB from DC ~ 8 Mhz
Frequency Response	Frequency Response
Attenuation	6.6 dB/1000 ft. @ 1MHz
Common Mode Rejection	40 dB @ 8 MHz
Impedance	Coax, Male BNC: 75 Ohms @ 1 MHz
Power	No power required.

Temperature Range	32º~131º F (0º~55ºC)
Humidity Range	0 ~ 95%
Wire Type	UTP (Unshielded Twisted Pair)
Wire Category	Category 2 or better. Best if > CAT 5e
UTP Connection	RJ-45. Pins 7 & 8. Reverse polarity sensitive.
Case	White ABS Plastic
Dimensions (male)	2¹/₄" x ³/₄" x ¹⁵/₁₆" (57 x 19 x 24mm)
Dimensions (female)	2" x ³/₄" x ¹⁵/₁₆" (52 x 19 x 24mm)