- 4 selectable frequencies to reduce interference
- Up to 50ft (15m) sensing distance
- Small size for a less conspicuous installation
- Simple to install
- Built-in AGC control to filter out lighting disturbances
- Signal strength indicator for easier alignment
- LED indicators for power, signal strength, and trigger
- Weatherproof for outdoor as well as indoor use (IP65)
- Mounting hardware included
Type | IR Multi-Frequency Single Beam Sensor |
Current Draw | Transmitter- 15mA@12VDC, Receiver- 30mA@12VDC |
Number of Beam Frequencies | 4 |
Number of Beams | 1 |
Sensing Range | Up to 50ft (15m) |
Infrared LED Wavelength | 940nm |
Operating Voltage | 10~24VDC |
Interupt Speed | 50ms |
LED Beam Spread Angle | Approximately ±10° |
LEDs – Red | Indicates transmitter and receiver are not aligned or beam is broken (Alarm) |
LEDs – Yellow | Dims/off when receiver’s signal is weak / off when beam is broken |
LEDs – Green | Indicates connected to power |
Output | NO/NC relay (set by jumper, default is N.C.) 0.5A@30VAC/VDC |
Operating Humidity | 0~95% |
Operating Temperature | -13°~131°F (-25°~55°C) |
Dimensions | 3-11/16″ x 2-3/8″ x 1-13/16″ (94 x 60 x 46 mm) |
Weight | 2.6-oz (74g) |
Enclosure | Weatherproof IP65 |
Product Information Sheet (PI)
Manual
Sensor does not detect the object |
|
Green power LED does not turn on |
|
Yellow LED or Red LED does not turn off |
|
Red LED lights when object is detected, but the output device is not activated |
|