Passive CCTV balun with ground loop isolator - Now Available!
EVT-PB1-V1TGQ*
*Please note that the "Q" indicates compliance with European RoHS environmental standards.
Small photo of CCTV balun with ground loop isolator
View Enlargement

Dimensional drawing of CCTV balun with ground loop isolator
View Enlargement


Product Info Sheet


Installation Manual
 
The new EVT-PB1-V1TGQ video balun with ground-loop isolator provides an inexpensive, flexible solution for dealing with ground loops on CCTV signal lines.

The EVT-PB1-V1TGQ is a Passive Video Balun with Ground Loop Isolator. A Passive Video Balun allows a CCTV camera's video signal to be transmitted over low-cost CAT5 unshielded twisted pair (UTP) cable instead of costly coax cable. They are suitable for full-motion color and monochrome cameras and provide a quick, low-cost way to connect CCTV cameras to a monitor, multiplexer, or video recorder at up to 980 feet away.

Video ground loop isolators are passive devices that help to reduce ground loop interference caused by multiple building grounds and differences in ground potential. Ground loop isolators can be installed in new installations or added to existing installations. Video ground loop isolators should be installed on the camera side of your cable.

Descriptions
  • Transmits a video signal up to 980 feet (300m).
  • Built-in ground loop isolation.
  • Built-in surge protector.
  • Gold-plated BNC connector improves reliability and life.
  • RoHS compliant.
  • Passive operation – No external power required.
  • Uses low-cost CAT 5 cable instead of costly coaxial cables.
  • High immunity from interference – Built-in impedance-coupled device and noise filter. Helps to reduce RF interference, cross talk, picture tearing, and other picture quality problems.
  • BNC and removable terminal block.
  • Small size, only 3-1/8" x 1-3/16" x 1-1/16" (79 x 30 x 26 mm). Note: case alone is 2-1/8" (54mm).
Specifications
Range* 980 feet (300m)
Maximum Input 1vpp
Insertion Loss <0.5dB
Frequency Response 0-3dB at 10MHz
Isolation Voltage 600VDC (Min)
Insulation Resistance 100 Ohms
Bandwidth Video DC to 8MHz
Impedance 75 Ohms (BNC) 100 Ohms (UTP)
Dimensions 31/8" x 13/16" x 11/16" (79 x 30 x 26 mm).
Temperature Range 32º~131º F (-0º~55ºC)
Wire Type UTP (Unshielded Twisted Pair) 24 AWG
Wire Category CAT 5 or better
Connector In BNC Male
Connector Out Removable terminal block
Case Black ABS plastic


*Note: Shorter range may result when baluns are used with DVR.


Copyright 2007 by SECO-LARM U.S.A., Inc. All rights reserved. Modified:
Manufacturer and Distributor of Security Systems and Accessories Worldwide.