Interfaces from SECO-LARM®   
SR-5202 / SR-5204
Power door lock kits
  • SR-5202 -- Includes two 5-wire (master) door lock/unlock motors.
  • SR-5204 -- Includes two 5-wire (master) door lock/unlock motors, plus two 2-wire (slave) door motors.
  • Complete with control module (2 built-in relays), door lock motors, 15A fuse, and all necessary hardware.
  • Compatible with nearly every vehicle alarm lock/unlock outputs.
  • For cars without factory-installed power door locks, or for vacuum-operated door locks (Mercedes or Audi) which require extra door lock motor for remote activation.
  • Manual operation of either front door will operate all door lock motors.

    		• Photo of SR-5204 power doorlock kit
    SR-5202-ME/SR-5202-MS
    Power door lock motors
  • SR-5202-ME -- 2-wire (slave) door lock motor.
  • SR-5202-MS -- 5-wire (master) door lock motor.
  • Add power door lock convenience to cars without factory power door lock systems.
  • Also for cars with vacuum-operated systems (Mercedes or Audi) which require extra door lock motor for remote activation.
  • Works with SR-5201-RMB or SR-5203UMB interfaces.
  • 12VDC, includes mounting hardware.

    		• Photo of SR-5204-MS doorlock motors
    SR-5201R /SR-5203A
    Power door lock interfaces
  • SR-5201R -- For alarms with specific separate negative lock/unlock signal outputs. No built-in timer - depends on alarm system for lock/unlock timing.
  • SR-5203A -- For alarms with no specific lock/unlock signals. One- or two-wire input. Built-in programmable (0.7/3.5-sec.) timer. Lock signal priority if lock and unlock signals received at same time.
  • Allows nearly any alarm to control nearly any type power door lock/unlocks.
  • Includes 2 pre-wired, built-in, heavy-duty 30A relays with protecting diodes and spike/noise suppressors.
  • Negative lock/unlock signal inputs.
    		•          
    Power doorlock interfaces
                        SR-5201R             SR-5203A
    SR-5220A /SR-5440A
    Power window roll up (or roll down) interfaces
  • SR-5220A -- Controls two windows, or one window and the sunroof. Selectable Hi/Low strength settings, with built-in safety cutoff.
  • SR-5440A -- Controls four power windows. The four windows roll up one-at-a-time.
  • Compatible with most power window systems. Works off momentary or constant ground trigger.
  • Built-in safety cutoff feature. Power window module will temporarily stop functioning if there is a current overload.
  • System override should ignition be turned on, doors unlocked, or any door opened. (SR-5440A only)
  • Interfaces with all ENFORCER® RF alarm systems.
    		•            SR-5220A
    Photo of SR-5440 power window rollup module
    SR-5440A          
    SR-5911
    Power trunk release module
  • Add power trunk release to cars without factory-installed systems.
  • Connect via relay to any alarm's auxiliary channel output.
    		•
    Go to General Sensors Section Return to Contents Go to our home page Contact Us Go to Battery Backup & Relays Section

    Test text = Phil Osborn