SK-919T3J 3-Button RF Transmitter with 68 billion codes
SK-919TP3J-RU 3-Button RF Transmitter with 68 billion codes
SK-917TP3J-RU - 3-Button RF Transmitter with CODEBUMP™ Anti-Codegrabbing
SK-919TP4J-NU 4-Button RF Transmitter with 68 billion codes
SK-917TP4J-NU 4-Button CODEBUMP™ Anti-Codegrabbing RF Transmitter
- Attractive - Like no other remotes on the market today.
- Ultra Thin - Just 5/16" (8mm). Fits easily in any pocket.
- Extreme Durability - Rubber buttons eliminate damage caused by electrostatic discharge and helps make transmitter water resistant. Gold-plated battery clips and contact points extend the life of the transmitter.
- Magic LED - Only appears when buttons are pressed.
- Frequency 315MHz (433.92MHz also available by request - SK-939TS4J-NU).
- Operates up to 500ft (150m).*
- 18 quintillion possible codes (SK-917T4J), plus RF anti-scan protection.
- Use with SK-910R4Q as well as SK-910RQ and SK-910R2Q.
- Includes 12VDC alkaline battery with handsome key chain ring.
- Size: 23/8"x13/8"x9/16" (60x35x15 mm).
- Private label available. Contact SECO-LARM for details.
|
SK-919TP4H-NU 4-Button, 15-Channel Hand-Held Slimline RF Transmitter
- Extreme Durability - Rubber buttons eliminate damage caused by electrostatic discharge and helps make transmitter water resistant. Gold-plated battery clips and contact points extend the life of the transmitter.
- Magic LED Only appears when buttons are pressed.
- Frequency 315MHz (433.92MHz also available by request).
- Over 68 billion (6.8x1010) possible codes.
- Operates up to 500ft (150m).*
- RF anti-scan protection.
- Compatible with all ENFORCER receivers (SK-910RQ, SK-910R2Q, SK-910R4Q).
- Includes 3VDC lithium battery and visor clip.
- One and two-button hand-held also available.
- CODEBUMP™ models also available with 18 quintillion possible codes.
- Size: 31/2"x23/16"x1/2" (89x56x12 mm).
- Private label available.
|
SK-910R4Q Four-Channel CODEBUMP™ Code-Hopping RF Receiver (Shunt/Momentary Operation)
Controls home automation functions, garage doors, alarm panels, etc., from up to 500ft (150m).* Similar to SK-910RQ & SK-910R2Q except with 4 outputs, independently programmable. Compatible with all ENFORCER transmitters. Mode switch for easy programming. 4 LEDs, one per channel, indicate RF reception, learn mode, transmitter cleared, output type. Add optional plug-in extended range antenna: SK-91ERSD.
- Use to control home automation functions, garage door openers, house lights, alarm control panels, motorized gates, lifts or other devices by remote control.
- Patented CODEBUMP™ anti-codegrabbing technology (requires use of CODEBUMP transmitter).
- Uses either fixed code (SK-919TD2A-U, SK-919TD1S-U, SK-919T4J, SK-919T1H, SK-919T2H, or SK-919T4H) or code hopping (SK-917T2A-U, or SK-917T4J) transmitters with up to 500ft (150m)* range using standard antenna.
- External extended range antenna optional. Plugs directly into receiver PC Board. If the ENFORCER SK-91ERSD (Dipole Antenna) is used, range will be up to 1000ft (300m).* If the ENFORCER SK-91ERSW (Discontinued Model Monopole Antenna) is used, range will be up to 800ft (240m).*
- Mode switch for easy transmitter learning.
- Easily Code-learns up to 15 remotes per channel.
- Stores codes safely in EEPROM for up to one year in case of power loss.
- Four Form C Dry Relay Contact (NO/NC/COM) Outputs. Each output rated 10A@24VDC.
- 4 Separate Channels / 4 Output Modes Each:
- a. Timed Momentary (1, 2, 3, 4, 5, 10, 30, 60 sec.)
- b. Toggle (On/Off)
- c. Latch (Output stays on until manually reset)
- d. Continuous or Validity (Output for as long as signal is received)
- All outputs are independently controlled. (i.e. Channel 1 can be toggle, Channel 2 can be one second momentary, etc.)
Note: If the timed momentary output is chosen for any channel, there will be only one time available for all channels. In other words, if a one-second output time is selected for one channel, then all other timed momentary outputs will be one second.
|
- Size: 43/8"x55/16"x11/8" (111x135x28 mm).
- Four LEDs (One LED for each channel) to indicate RF reception, learn mode entered, transmitted learned, memory cleared.
- Use to control the garage door, house lights, alarm control panel, or other functions that require momentary or shunt operation.
- In addition, these revolutionary receivers have:
- Hi-Q SELECTIVITY and a CODING IC for rejecting unwanted RF signals.
- HIGHER SENSITIVITY for greater operating distances.
- UNSURPASSED ANTENNA MATCHING CAPABILITIES so the receiver is less affected by how and where mounted.
- GREATER TUNING STABILITY so the receiver's frequency remains unaffected by shock and vibration.
|
|
