SD-927PWCQ

Wave-to-Open Sensor – White plate

The ENFORCER Wave-to-Open Sensor uses IR technology to request egress from a protected area or activate a device with the simple wave of a hand. Since no touch is required, this sensor is suitable for use in hospitals, clinics, labs, cleanrooms (to reduce the risk of contamination), schools, factories, or offices.

  • product_icon
  • Range up to 2″ (5cm)
  • White plastic single-gang plate
  • 3A relay, triggers minimum 0.5 sec or as long as hand is near the sensor
  • Quick connect screw-less terminal block
  • LED illuminated sensor area for easy identification.
  • Selectable LED colors (turns from red to green or green to red) to show sensor activated.
Type Wave-to-Open Sensor Wall Plates
Current Draw 50mA@12VDC
Sensing Range Up to 2″ (5cm)
Operating Voltage 12VDC
Reaction time 10mS
LEDs – Red Standby
LEDs – Green Triggered
Relay Type Form C (NO/NC/COM) 3A@12VDC
Output Time 0.5S or as long as unit is triggered
Switching Capacity 3A@24VDC
Operating Temperature -4°~131° F (-20°~55° C)
Dimensions 4-1/2″ x 2-3/4″ x 1-5/16″ (115 x 70 x 33.5 mm)
Weight 2.5oz (70g)

 

Product Information Sheet (PI)

Manual

Advertisement

FAQs

Answer:

  1. Check that nothing is remaining in range of the sensor including a cone of 60º from the centerline.
  2. Reduce the IR range of the sensor.
  3. Ensure that the sensor’s output duration potentiometer is not turned to maximum
  4. Check that the power voltage is within the sensor’s specifications.

Answer:

  1. Ensure that no strong direct or reflected light source is reaching the sensor.
  2. Ensure that sensor is sheltered from direct sunlight.

Answer:

  1. Increase the IR range of the sensor.
  2. Check that the power voltage is within the sensor’s specifications.

No upsell products found

Scroll to Top