E-931-S35RRQ

Reflective Photoelectric Beam Sensor, 35ft

  • product_icon
  • product_icon
  • For outdoors gates, garage doors, etc.
  • Adjustable sensing range
  • 12~240 VDC / 24~240 VAC Operation
  • Current draw: Up to 40mA@12VDC
  • For indoor or outdoor use (IP66 Weatherproof)
  • Pre-wired 6.5ft (2m) cord
  • Brackets and mounting hardware included
  • Compact size
  • New single-gang box and wall-mount brackets available

Typical Applications

  • Sensor for garage doors, outdoor gates or overhead doors
  • Sensor for industrial automation to detect objects on manufacturing line
Type NIR Reflective Photoelectric Sensor
Current Draw Standby- 12VDC@20mA; 24VDC@10mA, Active- 12VDC@40mA; 24VDC@20mA
Sensing Range 0.5′ to 35′ (0.1 – 11m)
Operating Voltage 12~240 VDC / 24~240 VAC
Reaction time 10ms (max.)
Light Source IR LED
LEDs – Red Active
LEDs – Yellow Standby
Output SPDT Relay Output
Switching Capacity 250VAC/1A, 30VDC/2A
Operating Temperature -4º~131º F (-20º~55º C)
Enclosure IP66 Waterproof
Trigger Output SPDT Relay output (NO/NC/COM)

Product Information Sheet (PI)

MANUAL

Trouble Possible Origin(s) Remedy(s)
Sensor does not detect the object. 1) Sensor sensitivity is not properly set.
2) Object may have a reflective surface
which confuses sensor
Change the angle of the sensor or readjust the sensitivity setting
Yellow LED does not turn on. 1) Dirty sensor and/or reflector.
2) Reflector and/or sensor is misaligned.
1) Clean the sensor and reflector with a
damp (not wet) cloth.
2) Adjust the reflector and/or sensor for
proper alignment.
Red LED lights when object is detected, but no output No continuity between sensor and alarm
device
Check cable from sensor to alarm device. Test sensor.

No upsell products found

Scroll to Top