- 1,500-lb (680kg) Holding force
- No residual magnetism
- MOV Surge protection
- Suitable for horizontal or vertical installation
- Anodized aluminum housing (US 28)
- Keyhole slot mounting plate makes installation easier
- Complete mounting hardware for typical installations
- Additional brackets available for easy mounting or atypical situations
- Detachable faceplate for easy access to wiring
- 12/24VDC Selectable
Holding Force | 1,500-lb (680kg) |
Operating Voltage | 12/24 VDC |
Current Draw | 500mA@12VDC, 260mA@24VDC |
Coil resistance | 46Ω ±10% per coil |
Housing material | Anodized aluminum (US 28) |
Operating Temperature | 14°~131° F (-10°~55° C) |
Mounting plate dimensions | 11-1/4″x1-9/16″x1/4″ (286x40x6 mm) |
Electromagnet Dimensions | 11-1/4″x1-11/16″x2-5/8″ (286x43x67 mm) |
Armature Dimensions | 7-1/4″x5/8″x2-3/8″ (185x16x60 mm) |
Weight | 11-lb, 1.2-oz (5kg) |
Product Information Sheet (PI)
MANUAL
FAQs
- The electromagnet is fitted with a metal oxide varistor to prevent interference, so do not install a second diode.
- Ensure that the control device is connected between the power source and the positive terminal of the lock
- Check to make sure the wires are securely tightened to the terminal block.
- Check that the power supply is connected and operating.
- Make sure the rubber washer is installed and free from damage.
- Make sure the electromagnet and armature plate are properly aligned.
- Make sure the contact surfaces of the electromagnet and armature plate are clean and free from rust.
- Check the power leads with a meter, and make sure 12VDC or 24VDC ispresent.
- Make sure the rubber washer is installed and free from damage.