E-941SA-1K5Q

Cerradura electromagnética de 1500 libras

La cerradura electromagnética para una sola puerta E-941SA-1K5Q de 1,500 lb es la forma ideal de asegurar una puerta contra la entrada no autorizada. Cuando se aplica energía a la cerradura electromagnética, se crea un campo magnético extremadamente fuerte. El electroimán es fuertemente atraído por la placa de armadura de acero que está montada en la puerta asegurada. Una vez que el electroimán está desactivado, la puerta asegurada funcionará normalmente sin ningún magnetismo residual.

  • product_icon
  • 680 kg (1.500 lb) Fuerza de sujeción
  • Sin magnetismo residual
  • MOV Protección contra sobretensiones
  • Adecuado para instalación horizontal o vertical
  • Carcasa de aluminio anodizado (US 28)
  • La placa de montaje con ranura tipo ojo de cerradura facilita la instalación
  • Hardware de montaje completo para instalaciones típicas
  • Soportes adicionales disponibles para facilitar el montaje o en situaciones atípicas
  • Placa frontal desmontable para facilitar el acceso al cableado
  • 12/24VDC seleccionable
Holding Force 1,500-lb (680kg)
Operating Voltage 12/24 VDC
Current Draw 500mA@12VDC, 260mA@24VDC
Coil resistance 46Ω ±10% per coil
Housing material Anodized aluminum (US 28)
Operating Temperature 14°~131° F (-10°~55° C)
Mounting plate dimensions 11-1/4″x1-9/16″x1/4″ (286x40x6 mm)
Electromagnet Dimensions 11-1/4″x1-11/16″x2-5/8″ (286x43x67 mm)
Armature Dimensions 7-1/4″x5/8″x2-3/8″ (185x16x60 mm)
Weight 11-lb, 1.2-oz (5kg)

Product Information Sheet (PI)

Doors does not lock
  • Check that the wires are securely tightened to the terminal block
  • Check that the power supply is connected and operating
  • Use a multimeter to check the resistance of coils inside the lock; see below
  • Make sure the rubber washer is installed and undamaged
Doors lock, but can easily be forced open
  • Make sure the electromagnet and armature plates are properly aligned.
  • Make sure the contact surfaces of the electromagnet and armature plates are clean and free from rust.
  • Check the power leads with a meter, and make sure 12VDC or 24VDC is present.
  • Make sure the rubber washer is installed and free from damage.
Delay in door releasing
  • The electromagnet is fitted with a metal oxide varistor to prevent interference, so do not install a second diode.
  • Ensure that the control device is connected between the power source and the positive terminal of the lock

No upsell products found

Scroll al inicio