- ETL, Conforms to UL Std. 294
- 80-lb (36kg) Holding force
- For spaces where small size is required, including cabinets, drawers, etc.
- Low current draw
- No residual magnetism
- MOV Surge protection
- Complete mounting hardware for typical installations
| Holding Force | 12VDC: 80-lb (36kg) 24VDC: 110-lb (51kg) |
| Operating Voltage | 12~24 VDC±10% |
| Current Draw | 12VDC: 60mA |
| Destructive attack level | Level I |
| Line security | Level I |
| Endurance level | Level I |
| Standby power | Level I |
| Operating Temperature | 14º~131º F (-10º~55º C) |
| Dimensions | Magnet: 2-3/4″ x 1-1/4″ x 3/4″ (70 x 31 x 19 mm) |
| Weight | 0.9-lb (410g) |
FAQs
- The electromagnet is fitted with a metal oxide varistor to prevent interference, so do not install a second diode.
- Ensure that the control device is connected between the power source and the positive terminal of the lock
- Check to make sure the wires are securely tightened to the terminal block.
- Check that the power supply is connected and operating.
- Make sure the rubber washer is installed and free from damage.
- Make sure the electromagnet and armature plate are properly aligned.
- Make sure the contact surfaces of the electromagnet and armature plate are clean and free from rust.
- Check the power leads with a meter, and make sure 12VDC or 24VDC ispresent.
- Make sure the rubber washer is installed and free from damage.
