- Polarized sensor is immune to shiny objects: Triggers only when correctly reflected light is detected
- Weatherproof (IP55) construction
- Anti-condensation housing
- 12-30V DC/AC 60Hz, 100mA
- Up to 33ft (10m) sensing range
- Round, ø31/4″ (82mm) reflector
- Form C relay: 0.5A@30VAC/VDC
- Beam status LED
- N.C. Tamper switch, 500mA@30VAC/VDC
| Type | Polarized reflective photoelectric beam sensor |
| Operating voltage | 12-30V DC/AC 60Hz, 100mA |
| Sensing Range | Up to 33′ (10m) |
| Current draw | Standby: 55mA@12VDC Active:40mA@12VDC |
| Response time | 10ms (max.) |
| LED indicators | Solid green: Good beam signal, properly aligned Alternating flash: Poor beam signal Solid red: No beam signal, triggered |
| Trigger output | SPDT Relay output (NO/NC/COM with built-in 10kΩ resistor on N.O. output) |
| Switching capacity | 0.5A@30VAC/VDC |
| Tamper switch | Solid, Good beam signal, properly aligned |
| LEDs | Alternating flash- Poor beam signal |
| Alarm Output | SPDT relay output (NO/NC/COM) |
| Switching Capacity | 500mA@30VAC/VDC |
| Tamper Switch | N.C. 500mA@30VAC/VDC |
| IP Rating | IP55 Weatherproof |
| Operating temperature | -4~131° F (-20~55° C) |
| Sensor does not detect the object | Change the angle of the sensor or readjust the sensitivity setting |
| The beam sensor LED will not turn green | -Clean the sensor and reflector with a damp (not wet) cloth -Adjust the reflector and/or sensor for proper alignment |
| Beam sensor LED lights when object is detected, but there is no output | Check wiring between the sensor and local alarm device |
