Reflective Photoelectric Beam Sensor - ETL UL325 Compliant, 35ft

E-936-S35RRGQ

Reflective Photoelectric Beam Sensor – ETL UL325 Compliant, 35ft

  • product_icon
  • product_icon
  • product_icon
  • Up to 35ft (11m) sensing range
  • Weatherproof (IP66) construction for indoor/outdoor usage
  • Pre-wired 6-foot cord
  • Bracket and mounting hardware included for both sensor and reflector
  • Adjustable sensing range
  • Compact size
  • Monitored output: N.C., 10kΩ resistor

Type Retro-reflective
Current Draw Standby – 60mA@12VDC, Active – 25mA@12VDC
Sensing Range 0.5~35 ft (0.2~11 m)
Operating Voltage 12~30 VDC/24~30 VAC 60Hz, 83mA
Reaction time 10ms (max.)
Light Source IR LED
LEDs Yellow LED (alignment), Red LED (power on, triggered off)
Alarm Output SPDT Relay output (NO/NC/COM, with built-in 10kΩ resistor on N.O. output)
Switching Capacity 2A@30VAC/VDC
Operating Temperature -4°~131° F (-20°~55° C)
Enclosure IP66 Weatherproof
Product Information Sheet (PI) (pdf, 0KB)
Download
Manual (pdf, 0KB)
Download

Sensor does not detect the object.
  • Change the angle of the sensor or readjust the sensitivity setting
Yellow LED does not turn on
  • Clean the sensor and reflector with a damp (not wet) cloth
  • Apply a coating of RainX™ to the reflector and the face of the sensor to help keep the units clear of moisture.
  • Adjust the reflector and/or sensor for proper alignment
LEDs turn off when object is detected, but no output
  • No continuity between sensor and alarm device. Check cable from sensor to alarm device. Test sensor.

Copyright ©2025 by SECO‑LARM U.S.A., Inc. All rights reserved. Supplier of Security Systems and Accessories Worldwide. The SECO‑LARM policy is one of continual development. For that reason, SECO‑LARM reserves the right to change specifications without notice. SECO‑LARM is not responsible for misprints or typographical errors.

Scroll to Top