Plug-and-Play Backup Power, In-line Backup Power (Discontinued)

SB-L10V1-20Q

Plug-and-Play Backup Power, In-line Backup Power (Discontinued)

ENFORCER Plug-and-Play Backup Power units provide backup power to power devices during temporary power outages. Installs between the original power adapter and the powered device and auto-selects 5, 7.5, 9, or 12VDC.

  • product_icon
  • product_icon

Discontinued Product: Replaced by SB-P1012-26Q

  • Real-time backup power with no break when input power is lost
  • DC UPS Auto-start
  • Batteries provided by GE™ (2600mAh user-replaceable Lithium Ion – SB-P1012-26Q /2000mAh lithium polymer – SB-L10V1-20Q)
  • Over-discharge, overcharge, overload, short-circuit, and surge protection on input and output
  • LED indicators for power and backup operation
  • Auto-recognizes voltage (5/7.5/9/12VDC) input and sets corresponding output
  • Additional indicator LEDs for output voltage and an audible/visible (LED) alarm warning of an overload, voltage issue, or low battery
TypeIn-line UPS
Input5/7.5/9/12VDC±10%
Input ProtectionOverload and short-circuit fuse
Input Jack Type5.5 x 2.1 mm DC Jack
OutputAuto-configure 5/7.5/9/12VDC±5%
Output Power Rating10W
Output ProtectionOver-discharge, overload, short-circuit protection
BatteryGE™ Lithium Polymer 3.7VDC/2000mAh
Battery ProtectionOvercharge, over-discharge, overload, short-circuit
Backup TimeHalf Load- 60 min, Full Load- 25 min
LED IndicatorsVoltage, power, alarm, backup
Output Cord12″ (30.5cm)
Output Plug5.5×2.1mm DC plug
Operating Temperature32~104°F (0~40°C)
Operating Humidity0~95% non-condensing
Dimensions3-3/8″ x 2-1/4″ x 1-21/32″ (85 x 57 x 42 mm)
Weight4.3-oz (121g)
Product Information Sheet (PI) (pdf, 0KB)
Download
MANUAL (pdf, 0KB)
Download
Backup time is shorter than
claimed
  • On initial installation, be sure that batteries have been charged for 24 hours before testing backup time
The power plug does not fit my unit
  • You may need to provide a power tip adapter to connect to your device (two adapters, both male and female)
Device does not turn on when
installed
  •  Check to see that all plugs are firmly connected at the device, the Backup Power unit, power adapter, and the AC wall outlet
  •  Check to see that the AC outlet is live
  •  Ensure that the Backup Power unit’s power LED is lit
  • Check for a short or overload. The Backup Power unit is designed to cut power when a short-circuit or overload is detected
  • Check that the device’s voltage is compatible (either 5, 7.5, 9, or 12VDC)
  • Press the “Off/Reset” button to reset voltage output
During a power outage, power is not provided to device
  • Check for a short or overload. The Backup Power unit is designed to cut power when a short-circuit or overload is detected
The alarm sounds (long beep) and the red alarm LED is lit
  • Ensure that the input voltage is either 5, 7.5, 9, or 12VDC
  • Ensure that the original power adapter is working and providing power to the Backup Power unit
  • Ensure that the device’s current draw is no more than 10W
  • Check for a short-circuit at the device
Scroll to Top