- H.265, Dual Stream IP Camera
- 1/2.8″ 5MP Low illumination CMOS
- D-WDR (Digital Wide Dynamic Range)
- 3.7mm Covert pinhole lens
- True Day & Night with ICR module
- 12VDC operation, 802.3af PoE
- 1440p Resolution
- 3DNR (3D Digital Noise Reduction)
- 2DNR (2D Digital Noise Reduction)
- Camera is hidden in a non-functioning PIR sensor housing
| Type | Covert PIR Camera |
| Formats | IP |
| CMOS | 1/2.8″ 5MP Low illumination CMOS |
| Resolution | 2880×1616, 1440p |
| 2DNR | Yes |
| 3DNR | Yes |
| D-WDR | Yes |
| Video compression | H.265 |
| Megapixels | 5MP |
| Lens | 3.7mm Pinhole lens |
| # of IR LEDs | 18 Covert (940nm) |
| IR Range | Up to 50ft (15m) |
| FPS | 25 |
| F Stop | 1.2 |
| Minimum Illumination | IR On: 0.01 Lux IR Off: 0.001 Lux |
| Electronic shutter speed | 1/50s(1/60s)~1/10000s |
| Shutter control | Yes |
| Primary stream rate | 32Kbps~8Mbps |
| Secondary stream rate | 32Kbps~8Mbps |
| Operating voltage | 12VDC, 802.3af PoE |
| Operating Temperature | -4°~140° F (-20°~60° C) |
| Dimensions | 4-1/16″x2-3/8″x1-5/16″ (104x60x34 mm) |
| Weight | 12.3-oz (350g) |
FAQs
Check that the correct power supply is in use.
Change the position of the camera.
Adjust the monitor’s contrast knob. Change the position of the camera.
Clean the lens using a soft, clean cloth. Check that the light source is adequate.
Change the position of the camera.
- Check that the camera is powered up.
- Check that the power supply’s polarity is correct. Check that the monitor is powered up.
- Check that the video cable connecting the camera to the monitor is connected properly.
