SD-9263-KS2Q

Outdoor Wave-to-Open Sensor – Single-Gang – French

The ENFORCER Outdoor Wave-to-Open Sensor is a full-featured exit plate which uses IR technology to allow egress from a protected area or activate a device with the simple wave of a hand. Since no touch is required, this sensor is suitable for use in hospitals, clinics, labs, cleanrooms (to reduce the risk of contamination), schools, factories, or offices.

  • product_icon

  • Adjustable sensor range up to 7″ (18cm)
  • Weatherproof (IP65) for outdoor use*
  • Stainless steel plate
  • 1.2A relay, adjustable trigger duration
  • 0.8~30 seconds or toggle
  • LED illuminated sensor area for easy identification
  • Selectable LED colors (turns from red to green or green to red) to show sensor activated

​*when properly installed

Type “Wave-to-Open” Request-to-Exit Plates with Adjustable Delay Timer, for Outdoor Use
Current Draw Standby- [email protected] / [email protected], Triggered- [email protected] / [email protected]
Sensing Range 2″~7″ (5~18cm)
Operating Voltage 12~24 VDC
Reaction time 10mS
LEDs – Red Standby (Colors are reversible.)
LEDs – Green Triggered (Colors are reversible.)
Relay Type Form C dry contact
Output Time 0.5~20 s, toggle
Switching Capacity [email protected]
Operating Temperature -4°~131° F (-20°~55° C)
Dimensions 4-1/2″ x 2-3/4″ x 1-1/2″ (115 x 70 x 39 mm)
Weight 108g
Enclosure Weatherproof IP65

Product Information Sheet (PI)

Manual

Sensor is triggering unintentionally.
  • ENFORCER Outdoor Wave-to-Open Sensors can be used either indoors or outdoors. However, due to infrared technology limitations, it is recommended that a hood or shield be used when installing outdoors to shield the sensor from direct light (sunlight, reflections from shiny objects, etc.). Direct light may cause the sensor to trigger unintentionally.

No upsell products found

Scroll to Top